BLZN4FN
1/2 ton status
Looking for some Np205 32 spline flanges where did you get your at and what do you think of them?
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Np205 flanges
- Thread starter BLZN4FN
- Start date
ford 205's run 32spline front outputs, so a stock front flange from one of those will work on your 32spline output. i've got one for my front output, but im using a HAD flange in the rear (to match the driveshaft). the HAD flanges are second to none in quality, but if you can get away with using the ford flanges front and rear, it would save you some money
the ford ones are also nice, because they have the same bolt pattern as the stock chevy shafts, so you dont need a new shaft (or modify old one) to run them
the ford ones are also nice, because they have the same bolt pattern as the stock chevy shafts, so you dont need a new shaft (or modify old one) to run them
an np208 front flange is 32 spline, ill be using it on the rear of my K5. i had the face turned down to accept my driveshaft though.
5280k5
1/2 ton status
I like my flanges from HAD, not the cheapest way to go but good quality.
Have you called over to Front Range Driveline? Talk to Bill see if he can help you out
Have you called over to Front Range Driveline? Talk to Bill see if he can help you out
BLZN4FN
1/2 ton status
I like my flanges from HAD, not the cheapest way to go but good quality.
Have you called over to Front Range Driveline? Talk to Bill see if he can help you out
Do you have flanges ft and rear on your 205??
