84400
Registered Member
I have an Sm465/np205 set up in my 77. It is a swapped in 10 spline unit. When I swapped it in I used the original rear yoke from my np203. Is this a 1310 yoke? I need to order a driveline ebrake for inspection. Looking at TSM but can't measure my current yoke.
Here is a link to the sizes available
http://www.tsmmfg.com/np205.html
They ID the 1350 but I am certain mine is smaller. So that leaves 1330 and 1310 but I think the 1310 was a libel off the np203.
I tried calling TSM but they did not have the yoke measurements for a 1310.
Any measurements would be helpful. Pretty sure it's 1310. I could order a 1350 yoke and conversion joint but that's more money I would rather not spend.
Here is a link to the sizes available
http://www.tsmmfg.com/np205.html
They ID the 1350 but I am certain mine is smaller. So that leaves 1330 and 1310 but I think the 1310 was a libel off the np203.
I tried calling TSM but they did not have the yoke measurements for a 1310.
Any measurements would be helpful. Pretty sure it's 1310. I could order a 1350 yoke and conversion joint but that's more money I would rather not spend.
