Post Your Fender Trimming Photos Here.

[Leper]

I guess you weren't done when you left the house!

 

[Citizen Rider]

Nope, still needed a bit more after flexing it out

 

[yunit]

The first is with 4" lift and 38's, axles not moved and the second if with 6" lift, 42's, front axle moved 2" forward, and the rear moved back 3".

 

[85HeartBurb]

Throttle Boss, what type of top is that?

offchamber the link is on the home page!!!

 

[spoolnaround]

6" with 38's ready for the 42's. I plan on 56's up front and 64's in the back with in the next few months.

 

[blazinzuk]

Heres the front a little different than some the back of my rig is trimmed just like everyone elses

 

[uberbeans]

this looks like the fender edges were "reinforced" or rolled or something. I am going to want to do this and am wondering how. Any info?

 

[Mudzer]

Heres mine...

 

[cegusman]

Rear fender chop done below

 

[mikey_d05]

Get your butt to Gilbert this weekend and you can see it in person.

 

[onetonbb74]

6" lift 36-12.5-15 tsl on 15 x 10 4.25bs

 

[ProJunkRacing]

Heres mine...

i want to see somemore of that truck....

 

[78Suburban]

I just love freaking everybody out... No, I didn't use a chain saw

 

[steve_kibbe]

Did you use your teeth?

 

[hawkeye649]

Looks like he just beat it with a hammer.

 

[tRustyK5]

this looks like the fender edges were "reinforced" or rolled or something. I am going to want to do this and am wondering how. Any info?

Funny how it looks that way in pic's, and it sure would be cool if i had actually done something like that... I think when I cut the fronts I left just a little of the edge roll area on. I'm actually pretty averse to adding edges and stuff...I have done it before and it's time consuming, but looks good. Less than two weeks later i smashed both fenders though. I know as soon as I spend a full day adding edges or other stiffeners I'll end up smashing it again. Without edges, I seem to be luckier.

Rene

 

[lrazer]

I just love freaking everybody out... No, I didn't use a chain saw

you use the back of a claw hammer?

 

[mouse]

Hows this?

 

[Kyle Strong]

Hows this?

 

[Hogback Fabrication]

Cut up pretty high (with a cut off wheel ) to get rid of rust