CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Power steering Pump Question
- Thread starter Redfrog
- Start date
83ZZ502_Jimmy
1/2 ton status
If the pulley/shaft is the same it should bolt up. Just check all mounting places.
My .02,
John
<font color=blue>"When all else fails, read the instructions, or get a bigger hammer"</font color=blue>
My .02,
John
<font color=blue>"When all else fails, read the instructions, or get a bigger hammer"</font color=blue>
Big_B_Murphy
1/2 ton status
Those pumps are the same. The brackets and pulley may be different, but the actual pump is the same.
<font color=red> It is just as much fun to build it as it is to bash it</font color=red>
<font color=red> It is just as much fun to build it as it is to bash it</font color=red>
The only thing that changed over the years was the fittings on the inlet and outlet and the valve. The valve can easily be swapped into the new pump from the old just by unscrewing the pressure outlet fitting. Of course, the pulleys and brackets may also need to be swapped. That same basic pump design is still being used today (with a few refinements).
<font color=green>Top signs you don't have a real 4x4:
4) Twin Traction Beam
3) Made by D.C.
2) 5 lug nuts
1) Unibody</font color=green>
<font color=green>Top signs you don't have a real 4x4:
4) Twin Traction Beam
3) Made by D.C.
2) 5 lug nuts
1) Unibody</font color=green>
