Raptor Liner

[Kyle1983]

Iirc, there’s a collapsible rod that goes between the bracket and your seat. When the seat is folded forward the rod holds it in place, release the lock and the seat goes back to its usable position.

Ok thank you! I will keep it!

 

[Kyle1983]

Anyone have any ideas on how to fill or seal holes that go completely through the back floor of the Blazer? I thought to just bondo over it but then I leave the hole exposed on the other side.

 

[jekquistk5]

Anyone have any ideas on how to fill or seal holes that go completely through the back floor of the Blazer? I thought to just bondo over it but then I leave the hole exposed on the other side.

Mig welder and sheet metal

 

[America.Mike]

I did the entire undercarriage on my blazer when I finished floors. I prepped with 80grit and acetone. Then I sprayed upol acid etch on and mixed upol and sprayed. I ended up putting 2 to 3 coats on depending on certain areas. It will take a grinder to pull that stuff off now.

 

[K5Devil]

I did the entire undercarriage on my blazer when I finished floors. I prepped with 80grit and acetone. Then I sprayed upol acid etch on and mixed upol and sprayed. I ended up putting 2 to 3 coats on depending on certain areas. It will take a grinder to pull that stuff off now. View attachment 319324View attachment 319325

Dang that’s clean!!

 

[America.Mike]

Thanks! been a lot of work and on a limited budget makes it even harder lol

 

[Kyle1983]

I did the entire undercarriage on my blazer when I finished floors. I prepped with 80grit and acetone. Then I sprayed upol acid etch on and mixed upol and sprayed. I ended up putting 2 to 3 coats on depending on certain areas. It will take a grinder to pull that stuff off now. View attachment 319324View attachment 319325

Damn that's on another whole level. I don't have the resources for that. Damn it's nice!

 

[Kyle1983]

Hours with a putty knife and heat gun.

One more black pad on the passenger side.

Will a wire wheel attachment remove everything that remains?

 

[Kyle1983]

Does anyone know why these are here?

 

[imiceman44]

Does anyone know why these are here?

View attachment 320038

Can you get a better picture of one?
Looks custom, normally there is a trim piece for the carpet and only sheetmetal screws.

 

[Kyle1983]

Can you get a better picture of one?
Looks custom, normally there is a trim piece for the carpet and only sheetmetal screws.

Thank you for the response. I will get a better picture. No idea what they could be for?

Do you think acetone will remove that black residue from those black pads? I think they were for sound deadening.

 

[jekquistk5]

Wire wheel worked well for me to get the last little bit off.

 

[89WhiteBlaze]

Ever finish this project? Curious how the raptor turned out?

 

[Kyle1983]

Ever finish this project? Curious how the raptor turned out?

It's on hold. Unfortunately I have no workshop. Being that it's winter there is no possible way unless I pay a shop. Everything is on hold but I will update as I go along. Thanks for checking back!