rims and tires

[RIPPEDK5]

Yeah im gunna have to see about getting one...


Trucks gunna look funny too.. measured my truck (at 75" wide- fender flare to fender flare)

and right now with rims on the axle as it sits on the stands is at 82" wide .. probably could have gone smaller on the rims (width wise) but that just wouldnt be a custom enough look lol

and if your wondering why i sold my grinder, the thing almost killed me twice, nearly gutting me...my shirt saved my life....couldnt safey gring anything with it, all it would do is just kick on ya

 

[xenomarine]

Did you lose the side handle thing? I've never had a mishap like that, even without the extra handle. Your old grinder must have been powerful as hell. Even my brand new dewalt doesn't do that.

 

[RIPPEDK5]

Yeah even with the handle it kicked bad. Im not exactly a small guy either too lol.. i gave it away cause it was better then smashing it with a sledge hammer...

I am just gunna take them to.my buddies and put them to the bench grinder. It was an 8" grinder.

 

[xenomarine]

Oh haha that thing probably was a little more powerful than mine with a 4.5" wheel.

 

[RIPPEDK5]

well gunna make short work of them calipers lol mybuddy lent me a 10" grinder

i think im gunna need battle armor for this one

his advice--" all you need is an idle with this bad boy"

 

[RIPPEDK5]

waiting for my gears to show up one of these weeks

and taking the rust off the axle

trying to figure out what color to make it and if i should put a picture on the diff cover

and coming down to the wire to decide if I should put some sort of street tire on it, or go with an all-terrain/mud-terain

any ideas on either


(the truck sees mainly street, but does have to go through snow,minor rough roads, and the occasional ride off the sidewalk into the grass knoll