buffblazer
1/2 ton status
have a guy im talking to about the roll bar out of his 82 chevy. what would yall pay for a Factory roll bar, and whats the most you would consider paying for one?
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Roll bar price
- Thread starter buffblazer
- Start date
Depending on how clean it is, if its not rusty, I would say low bal $100.00, to a reasonable $200.00 bucks
Steel is expensive these days, but a factory bar is very basic. I personally would not pay more then the 100 bucks. For 200 bucks I could buy 200 bucks worth of tube and build one the way I would want it, but I have a bender so Im biassed. If you have no means to bend 200 bucks aint too bad. 100 bucks worth of tube might not get enough tube to build one even like the factory bar.
blazin' j
1/2 ton status
is it for a blazer or a truck??? if its for a truck, you may want to measure it to make sure it fits under your cap...i'd say $100 as well
George_Pimpdaddy
1/2 ton status
also is it for the front or the back?
buffblazer
1/2 ton status
well the guy is selling a 82 blazer (local ad) and said yada yada about the blazer then at the end it says comes with roll bar, not installed. so before i called him i was going to see what i could get it for. i dont know what it looks like.
pauly383
Daddy383
I wouldn't pay over 100 bucks for one . Especially since your in Colorado , and I assume lots of members there would help you bend a few tubes for a roll bar if you don't buy the stocker .
buffblazer
1/2 ton status
ya im not in desperate need for it right now, need the money for other stuff (finish motor, new winch bumper,pay off winch,ect) so i figured i would offer 50 bucks and if he said no i would go up to 100 and not any more.
