Suburban help- seat belt pic request

[jp0863]

Finally got the interior line-x'd, so now i'm putting everything in its place. Got to the front seat belts, but ran into a problem. Can someone take a pic of the seat belt mounting bolts, both between the front seats and the outer belt assembly?.. Seems the bolts that I thought went in there, aren't threading. Before I screw something up, can someone snap a pic for me so I can go through what I have and make sure i'm using the right ones. I stripped the interior months ago and don't remember.

 

[mr250twostroke]

If you post a pic of your bolts ill point them out. I just put my interior back in yesterday... They take a 13/16's socket.

 

[mr250twostroke]

And were the holes blocked before the Line-X was applied?

 

[jp0863]

Yeah the holes were blocked prior to the line-x. If the take a 13/16 then I have the right ones. The other bolts I have are torx, so that answers my question. Thanks.

Are all four belt bolts hex head? Just to make sure.

 

[mr250twostroke]

Yeah the holes were blocked prior to the line-x. If the take a 13/16 then I have the right ones. The other bolts I have are torx, so that answers my question. Thanks.

Are all four belt bolts hex head? Just to make sure.

Hex head on the floor (all 4), torx on the b-pillar.

 

[jp0863]

Well here's what I have so far. They thread in, by hand only a few turns. Put a sock on the one i'm trying and it tightens, but is ot down to the head when tight. I would guess there is probably 3 or 4 threads left before it bottoms out, but it isn't bottomed out yet. Any thoughts? I'll go try the others to see if it's the same all around.

 

[mr250twostroke]

Wierd, mine went in fine. Your threads should be totally visible without carpet/padding. Try them from the bottom side 1st?

 

[jp0863]

Well just seems to be the outside bolts. Thanks for your help, i'll probaby hav to chase the threads.