Sold Th400-np208 adapter

[mechted]

Relisting these from about a year ago:


ORD 32 spline, 2" pilot, rear output flange. Dual pattern 4.25"/3.5" bolt circles. Was installed then removed. Had to change it for the correct size pilot. Nothing wrong with it. New hardware from ORD was never used. $SOLD

1350 32 spline rear output yoke. $SOLD

W-style crossmember with skidplate. No bends/cracks. Removed due to magnum install. $SOLD




TH400 - NP208 round pattern adapter. 2.5" face to face. Good seal surfaces, nothing broken. No seals. $150 120 shipped.

 

[mechted]

TMR customs NP205 rear support. New, never installed. $SOLD

 

[az_762_nato]

That flange fit the superduty CV?

 

[thatK30guy]

Shoot me a PM with your PayPal info for the W-crossmember and skidplate. I'll take those.

 

[mechted]

That flange fit the superduty CV?

I think so. Its this one:

1350 CV flange for 32 spline output shaft, 2" pilot, for aftermarket CV driveshaft

1350 CV flange for 32 spline output shaft, 2" pilot, for aftermarket CV driveshaft Includes seal, nut, and hardware.

www.offroaddesign.com

 

[imiceman44]

I think so. Its this one:

1350 CV flange for 32 spline output shaft, 2" pilot, for aftermarket CV driveshaft

1350 CV flange for 32 spline output shaft, 2" pilot, for aftermarket CV driveshaft Includes seal, nut, and hardware.

www.offroaddesign.com

I will take the 2 yokes and the 205 support.
Ship all in one box saves you some shipping.
PayPal?