Discussion in 'The Garage' started by zcarczar, May 17, 2005.
Yeah, that one's probably fine.
A little JB weld and you will be good to go
i was thinking duct tape, but i guess JB Weld would work too.
I was gonna weld em back up and grind it down.
i'd clean the yellow writing off first,it may affect your overall performance.
What axle are they from and how did you break them?
looks like the hub held up
Thanks for the laugh. I enjoyed the pictures. Have you considered super glue? Works wonders on my cuts.
JB weld and duct tape are no match for chewing gum and baling wire.
Up here we use a little birch bark and bear grease
You might laugh at that, but it's been done to get a 5 ton open diff rear axle get moving again. We had to do that to my buddy's Boom truck to get it out from a rural road back to civilization
Separate names with a comma.