Two questions: tach wiring and trans press port on a 2006 Savana

[cabledawg]

I recently had to replace the trans on my 06 Savana because a valve or something stuck open and we didn't catch it in time. So because of this I want to add a few gauges like I did on my Burb before I switched it to a manual trans. But I have two questions: where do I connect the tach pickup wire on the engine (it's a 6.0l gasser) and where is the pressure port located on a 4L80E trans? My Chiltons isn't helping much.......

 

[sweetk30]

heck here for tach http://www.lt1swap.com/2000harness.htm

and fyi ls engines are 4 cyl factory tach signal and some require resistor to work .

if you haven't got a set of gauges yet check this out . http://www.aeroforcetech.com/ plugs in to obd2 port .

 

[cabledawg]

Sweet! K30......

Well for $407, I can see all the stuff my laptop does, but while I'm driving down the road

I think this is the solution to both problems although it doesn't do the line pressure, since I can see a few other trans related things I might not need the pressure readout. Good find and my wife thanks you

 

[sweetk30]

if you have smart phone there is apps for stuff like this also .

and $400 did price go up ? or you pick options ?

Sweet! K30......

Well for $407, I can see all the stuff my laptop does, but while I'm driving down the road

I think this is the solution to both problems although it doesn't do the line pressure, since I can see a few other trans related things I might not need the pressure readout. Good find and my wife thanks you

 

[sweetk30]

ya I went and rechecked its 249 for a single gauge kit .

and If I recall it rotates 2 reading at a time for a total of 8 in a cycle as you set the unit up .

 

[cabledawg]

Yeah I went all in. If I have to ask the Mrs Dawg for money, I might as well go balls deep