Updated: Driveshafts / axles / ac / engine / core support / bumper / more

[bdegs]

Here are all the parts currently for sale from my 77 blazer. If you need anything specific ask. I have 2 blazers that I am making one from so I probable have what you need.

Complete 350, about 4 years old but only about 15k miles $800 obo

Complete AC system from by blazer. Everything! including condenser, evap, comperessor, receiver/dryer, lines, electrical... everything. $?

D70 drw $400 obo

Corp 12 with Auburn Posi $200
np 208 $50 obo

rear driveshaft 1330 u-joints $50 obo
1330 cv rear slip yolk driveshaft SOLD
2 1/2 ton front drive shafts $50e
stock chrome front bumper from 76ish K5 $40
Entire core support for same truck $20
Rear tailgate with glass $40
Conv top for 76 K5, rear fiberglass was cut a bit but windows are good $0
4 steel 5 lug chrome wheels with small tires, not great condition but hold air $40

 

[teamhickman]

Is the 12B complete? What gears are in it?

Any interior stuff left?

Thanks,

Andrew

 

[bdegs]

Is the 12B complete? What gears are in it?

Any interior stuff left?

Thanks,

Andrew

12B is complete with an auburn posi that works great. Gears are 3.73 I believe.

Have some interior stuff, what are you looking for?

 

[teamhickman]

PM Sent.

 

[MTBLAZER89]

pics of rear driveshafts? Lengths?

 

[Krazy Kid]

pic's of the front driveshaft, would like first dibs on it, if it is what I need.

 

[bdegs]

pics of rear driveshafts? Lengths?

I will post pics and lengths tonight. Are you looking for the 1-ton or 1/2 ton?

pic's of the front driveshaft, would like first dibs on it, if it is what I need.

Pics/lengths tonight. You are first in line.

 

[Krazy Kid]

What ever will fit

 

[bdegs]

Here are the specs and pics of the Driveshafts:
2 front 1/2 ton: 33''-36''
1 front 1/2 ton: 31''-43''

Rear 1/2 ton slip yolk cv joint: 33''
Rear 1ton 1330 joints: 41''-46''

 

[MTBLAZER89]

Dibs on that rear CV slip yoke shaft. Is 33" just the length of the tube? Can I get you to measure from the center of the joint closest to the slip to the center of the pinion joint. I'll measure mine tonight and make sure its close. 1330 joints at both ends?

 

[bdegs]

Dibs on that rear CV slip yoke shaft. Is 33" just the length of the tube? Can I get you to measure from the center of the joint closest to the slip to the center of the pinion joint. I'll measure mine tonight and make sure its close. 1330 joints at both ends?

It was 33'' from the outside of the joints, so take off 1/2 inch. I will measure the u-joints again.

 

[MTBLAZER89]

I'll take it. My non CV is right about 32" to the outside of the yokes so if anything I can shorten it.

I'll take that long slip front too if it's still available.

Figure a shipped price for both and PM me your info so i can pay ya