I am currently updating my 79 blazer from my 89 donor blazer.
i ran into a problem today i have the 89 motor trans and transfer case installed and i was going to hook up the drive shafts, but i relized that the yoke on the rear of the 79 would not except the drive shaft from the 89. The unvirsal joints are slightly bigger from the 89
any help or suggestions would be greatly appriaciated
i ran into a problem today i have the 89 motor trans and transfer case installed and i was going to hook up the drive shafts, but i relized that the yoke on the rear of the 79 would not except the drive shaft from the 89. The unvirsal joints are slightly bigger from the 89
any help or suggestions would be greatly appriaciated
