14 bolt FF 4.10s Wanted in Northern CA

[TopOff]

14 bolt FF axle assembly with 4.10s wanted in North CA

Ideally it will have a Detroit in it, or else open.

Thanks.

LMK

 

[afroman006]

I have a set and an open carrier in Texas. If you want them $50 for the gears + $30 for the carrier + shipping. Lemme know. Thx

 

[dremu]

I think the OP meant a whole axle assembly -- donno though.

-- A

 

[tweaker]

I've got a 14 bolt here in modesto, asking $60. it's complete, but i only know it came out of a 1978 chevy 1ton van. i payed $150 but that was before i found out about CK5 here's the pic check it out and if you like shoot me a pm

 

[TopOff]

Oops sorry. Yah, I am looking for the whole thing. /forums/images/graemlins/laugh.gif

 

[dremu]

Are the van ones a different width or spring perch width?

-- A

 

[tweaker]

ok, did the measure on the two axles. /forums/images/graemlins/thinking.gif

my truck 14bolt 40 1/2" center to center spring perch
51" inner dust shield to shield

the van 14bolt 50 1/2"
56" inner to inner

over all it's 5" wider and it could be mounted into a truck by adding two new perches at 40 1/2" /forums/images/graemlins/woot.gif

i can't use it cause mine needs a perch located at 47" on center for my 1988 k1500. hope this helps.

 

[kennyw]

There is a guy in OR parting out a 3/4 ton 4x4. That would be a bolt in deal for you and I am even heading to Redding on May 8th and could haul it down. Check the Pacific forum and you will see his thread /forums/images/graemlins/thumb.gif