CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
1971 K/5 Blazer
- Thread starter HINZ28
- Start date
install side to side, not front to back... it's a lot easier to tilt the entire body to one side and replace all 6 mounts at once.
-G
-G
Knocked one side out in a couple hours. Being all original mounts they came out better than the last one I did that had been replaced before
Burt4x4
1 Ton First Gen
Those poly mounts look to be Energy Susp?
Good NOT TO go red, Black has poly graphite="Anti squeek" well from Energy anyway...
I did the black Energy Susp black install in 1993 = All Good to this day! Best way to keep the body on the frame.
PS ~ DO NOT over tight your carriage bolts. Poly does not fair well if you squeeze it = careful on torque. Just get it nice and snug and use nylon lock nut < <
Good NOT TO go red, Black has poly graphite="Anti squeek" well from Energy anyway...
I did the black Energy Susp black install in 1993 = All Good to this day! Best way to keep the body on the frame.
PS ~ DO NOT over tight your carriage bolts. Poly does not fair well if you squeeze it = careful on torque. Just get it nice and snug and use nylon lock nut < <
Body mounts done 
This brand new rear bumper came with one of my trucks. Tossed it on
Interior started with just about with nothing. Slowly piecing it together. I have some factory low back buckets and console being redone currently. Can’t wait to get them back and installed.
This brand new rear bumper came with one of my trucks. Tossed it on
Interior started with just about with nothing. Slowly piecing it together. I have some factory low back buckets and console being redone currently. Can’t wait to get them back and installed.
Subscribed
