3/4 ton front hubs and backing plates

[85 Jimmy]

*EDIT*
i found a 14 bolt here but i need the backing plates and front hubs to finish the big parts i need

 

[thatK30guy]

Check here: http://coloradok5.com/forums/showthread.php?t=226249

I have a buddy who goes to Oklahoma and Texas quite a bit looking for derby cars. He could possibly deliver these axles down there close to where you could meet him.

 

[BulldogK5]

Try the Mississippi market Bulletin. There are a few listed in there this month. It comes out on the 1st & 15th of each month. There are some smokin' deals in there usually. Go under archived issues to the current issue. It will have to load a pdf and then scroll around. The truck parts are usually about page 15.

This one was listed in this issue.

3/4 front end & rear end for older
model Chev. truck, $200 each or $350
for both. Lincoln Co., Brookhaven,​

601-757-4625.

 

[BulldogK5]

Forgot the link if you wanted it.
http://www.mdac.state.ms.us/n_library/pub_form/mkt_bulletin/index_marketbulletin.asp

 

[85 Jimmy]

ttt

i'm just going to piece together the front end but still want a 14ff with 3.73's

 

[85 Jimmy]

ttt

 

[BulldogK5]

Did you call about those in Brookhaven? I was just wondering what they were myself.

 

[85 Jimmy]

yeah, i called the day you posted that up and he said he already sold them...

 

[BulldogK5]

I'll keep checking around here then.

 

[thatK30guy]

Ok, now those are gone, I will get you the pics of mine. My buddy is talking about a road trip on the weekend of March 8th down to Oklahoma.

 

[85 Jimmy]

i found a 14 bolt here but i need the backing plates and front hubs to finish the big parts i need

 

[nvrenuf]

Try Chris @ the Performance Off Road there in Gulfport, 228-326-7826. He has a lot of used stuff so it may be worth a try.

 

[85 Jimmy]

oh yeah, i forgot all about that place, thanks

 

[nvrenuf]

Chris is a good guy and usually has some good deals, he's helped me a lot with my K5 project.

 

[85 Jimmy]

chris said he is fresh out... but he took my number and said he'd call if he gets some

 

[BulldogK5]

These were posted earlier. Look near the bottom.
http://coloradok5.com/forums/showthread.php?t=227385

 

[gmc4cw]

do you still need these? I am getting ready to start parting out a 3/4 ton truck and will have a set.

 

[neverendingproject]

I have a set of backing plates for cheap. Let me know.

 

[85 Jimmy]

ttt

pm sent to gmc4cw

neverendingproject, i will let you know if i can't find any