A long shot... Marlin Crawler rock sliders??

[85 Jimmy]

I was rewatching some dirt every day episodes and they used Marlin crawler sliders on the Mazda with one tons. They had to set the slider angle and weld it all together. If yours comes in with the legs already welded on, I'll email them before I order mine.

 

[Bent77]

I was rewatching some dirt every day episodes and they used Marlin crawler sliders on the Mazda with one tons. They had to set the slider angle and weld it all together. If yours comes in with the legs already welded on, I'll email them before I order mine.

I’ll post pictures since everyone is curious

 

[ChrisPerry]

Says out for delivery!

Are they there yet?

 

[Bent77]

Are they there yet?

 

[Bent77]

.

 

[fastazz81]

The important question is what color are they going to be?

 

[Bent77]

Silver, I mean Alberta Chrome

 

[konajoe]

Nice... the 70" version would fit my shortbed perfectly.

 

[Bent77]

Nice... the 70" version would fit my shortbed perfectly.

Yeah I had an idea the 80” would also fit my regular cab, but should turn out ok

I post some install pics when I get there

 

[muddermilitia]

It's Tuesday, did you install them yet?

 

[Bent77]

They are installed on the floor

unfortunately not slated for install until March or April. I’ve spent more time shoveling snow than doing anything useful

 

[85 Jimmy]

Just based off of some measurements, are the legs that weld to the sliders and frame going to be long enough?

 

[skunked]

Just based off of some measurements, are the legs that weld to the sliders and frame going to be long enough?

not even close. I sleeved the trailgear sliders I used so they were long enough.

 

[nvrenuf]

unfortunately not slated for install until March or April.

This will be too late for the Southeast ride the first weekend of April.

 

[Bent77]

This will be too late for the Southeast ride the first weekend of April.

Likely so. My part time job in Tennessee also fell through

 

[Bent77]

Just based off of some measurements, are the legs that weld to the sliders and frame going to be long enough?

I was planning on buying a stick just to make legs

 

[nvrenuf]

My part time job in Tennessee also fell through

Just as well, I hear the shop foreman is a harda$$.

 

[Bent77]

 

[Bent77]

Photo dump of the passenger side

I should have gotten the 80” bar for the k10 long bed. So these were lengthened to 77”, because it’s a ‘77

 

[Bent77]

FYI

legs ranged from 15.5” for the legs to the lowest part, almost flat. 17” legs where that had to angle up more

5 legs aside, I burned up most of a 20’ stick