CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Allied Beadlock Leak**FOUND LEAK**FIXED**
- Thread starter MTBLAZER89
- Start date
Well I think I got it! 
I drilled out the hole with a 1/16" bit and got a bunch of black powdercoating out of it. I used a dremel to wallow out the top of the hole a bit.
I tried a bead over it with t same result.
So I ground the weld off and the hole was filled with weld so I smoothed it out with the grinder some and tried another.
It seemed to work this time. Excuse my mediocre flux core welds
The bead seemed to flow well over the spot where the hole was, but I decided a bead on each side wouldn't hurt.
Put a couple of tacks to compensate for my welding skills
I wasn't sure if i should or not, but I smoothed the weld out a bit with a flapper wheel then I hit it with some paint.
It didn't turn out beautiful, but I think it will be good If not I'll just get a new wheel from Allied
I drilled out the hole with a 1/16" bit and got a bunch of black powdercoating out of it. I used a dremel to wallow out the top of the hole a bit.
I tried a bead over it with t same result.
So I ground the weld off and the hole was filled with weld so I smoothed it out with the grinder some and tried another.
It seemed to work this time. Excuse my mediocre flux core welds
The bead seemed to flow well over the spot where the hole was, but I decided a bead on each side wouldn't hurt.
Put a couple of tacks to compensate for my welding skills
I wasn't sure if i should or not, but I smoothed the weld out a bit with a flapper wheel then I hit it with some paint.
It didn't turn out beautiful, but I think it will be good
If not I'll just get a new wheel from Allied 
Slapperbar
Retired Navy NDT Examiner
If it holds air you did it right.
Well I mounted a tire on it tonight and put it at 26 psi. I'll update this tomorrow after work
