Well thats the plan keeping the tube as close to the body lines. I'm thinking of doing just tube for the bed section.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
And it continues build thread. Dead.. sent to the scrapyard
- Thread starter jekquistk5
- Start date
Started on the rear 
left it just tacked in place. Gotta come up with a brace for the back of the frame. Its way weak.
Here is the final concept.
left it just tacked in place. Gotta come up with a brace for the back of the frame. Its way weak.
Here is the final concept.
Lookin good. Are you going to hack the rear frame off right behind the rear leaves after you swap the 63s in?
Yup, if my measurements are correct exactly where the tubes land on the frame is where the mounts will be
Getting better at coping tube
Stopped working on the rear because I want to make sure the tires do not hit where I plan on running the fender things.
Also through a blazer seat in there for kinda mock up. Gonna go find a seat from a Jeep TJ or YJ
Added the rear bar for the 4 points.
Need Ideas of for dash bar for people that ran their cage through the dash.
Stopped working on the rear because I want to make sure the tires do not hit where I plan on running the fender things.
Also through a blazer seat in there for kinda mock up. Gonna go find a seat from a Jeep TJ or YJ
Added the rear bar for the 4 points.
Need Ideas of for dash bar for people that ran their cage through the dash.
dave I missed this post but yes the top of the windshield is welded to the A pillar tubes
you could bury it down in there, wich was my original plan, but i can still see the halfway point of my hood in my seat, so putting it down isnt going to do anything, except let me see more hood lol
Got the 10blt pulled and got the rotors put on the 14 hubs.
Still need to place an order with kert for ubolts and spring plates. Its the little things that I keep forgetting about.
Still need to place an order with kert for ubolts and spring plates. Its the little things that I keep forgetting about.
Progress! When is that thing going to be trail worthy?
landed the 60, dropped the old 14sf
What's in the middle of your frame on that side?
Still going to be ready in 2 weeks?
Still going to be ready in 2 weeks?
Highly doubt it. Still have to fab up tripple stick for the doubler
and thats the only spot on my frame that has undercoat left on it from the PO... haha
It's funny because the axle, springs, frame and floor all blend together in that picture almost, except for that spot. It's camo!
I actually worked on my rig the last two days. Hard getting used to working on stuff with this new ring on my finger . anyways rear suspension is hung, just need to grind of the perches and reweld them to the correct width on the 14. Feels good to build stuff again. Horray for no wedding planning.
. anyways rear suspension is hung, just need to grind of the perches and reweld them to the correct width on the 14. Feels good to build stuff again. Horray for no wedding planning.
