axle shaft install*done-with pics*

[chevy wrangler]

here are some recent pics(yesterday)didnt have camera till i got home so no action shots

 

[chevy wrangler]

here is pics of the new truck

 

[87'k5boggin]

muddy looks like you need 2 1/2 ton axles

and a 454

sorry for hijack but, ive been considering going 2 1\2 ton on my truck and was wondering how hard it was to get everything mounted and how the driveshaft issues where taken care of?

 

[Chrisblazzer89]

here are some recent pics(yesterday)didnt have camera till i got home so no action shots

Is that cow poop!!

 

[chevy wrangler]

i dunno how hard it would be, i'll stop by the shop and ask the fadricator


no its mud and i actually found a mud "hole" got in it pretty deep

 

[87'k5boggin]

ok cool i am going to be getting rocks for my boggin truck.

 

[chevy wrangler]

*update* everything is holding up very good, i dunno what i would of done with out you guys

 

[chevy wrangler]

it held up to where the slined coupler could not!!

 

[chevy wrangler]

luckly i got a new one

thanks thatk30guy

oh and here is a pic of the truck when it sat for a week and a half

enjoy

 

[TexasBlazerBoy]

luckly i got a new one

thanks thatk30guy

oh and here is a pic of the truck when it sat for a week and a half

enjoy

In the last pic, are you replacing the flywheel/flexplate? If so how hard is this to do?

 

[85mudbogger]

In the last pic, are you replacing the flywheel/flexplate? If so how hard is this to do?

well theres only 6 bolts there just use an impact to get them off, farely easy

 

[TexasBlazerBoy]

well theres only 6 bolts there just use an impact to get them off, farely easy

You don't have to move the tc back or anything else, lower the transmisson?

 

[chevy wrangler]

umm the t-case and tranny came out whern i replaced it,

i needed to check em