Fb market should have a decent selection resell on used tools/boxes is pitiful
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Back In the Saddle Again
- Thread starter K5Devil
- Start date
Horror freight has the 5 draw general cart on sale this weekend. Is pretty decent can get quit a few tools in it
Yeah Im getting a horror fright box
My first day real day I installed a 4link arm kit front and rear also panhard bars. on a '22 Jeep JL. Definitely was a pain not having a tool box. Did beat the time but not by much. I messed up and loosened left and right lower arms which caused axle to pull back. Without that mess up I would have killed the time standard. Learning a lot about jeeps. the Boss is a super cool young guy gotta be my age. Totally gets it and is just easy going which I completely appreciate.
I am in the northwest area. I appreciate the info.
I think the issue with the heater may be the blend door. Anyone know where I can find the info on properly adjusting that on top the heater box? Its screaming now when I turn the heater on like the blend door isn't actuating properly.
- Joined
- Apr 23, 2016
- Posts
- 2,937
- Reaction score
- 5,014
@Fastereddie Is a wizard with all things K5. If he's surfing the thread I'm pretty sure he'd chime in for you.
finally got around to fiddling with the heater and figured it out. Its dropping to around 10 ° here at night and having heat is mandatory. So if you look at the diagram. The pivot shaft (#13) will not actuate all the way towards driver side to allow the heat to stay hot. I have to force it over. I think this is because I do not have the rod that goes from it (#13) to (#16) properly adjusted. I did get it shoved over enough that it blows hot now and have set the rod there so it holds it. However, if I actuate the switch on the unit for Def-Heat-AC it will not return back to allow the heat to stay on. Also, I could not get the def to work at all. Confirmed All diaphragms have manifold vac working. 
Could be a mouse nest in there or something too?
I think there is definitely something blocking the def and keeping that door open. I will eventually take it apart and figure out whats going on. But its way to cold currently lol
Been building stuff for other people lately. Just put this Game changer kit on this jeep. Front tires are flat on the ground. Really digging this job. Working on a SBC swapped 69 FJ cruiser right now. Ill post up some pics soon. Got a square in here for a transfercase rebuild ill post up some pics of that too. First time ive ever been in a shop that is so laid back. Ive always been pushed super hard to make the impossible possible and this job is just really laid back.
Oh yeah and check out this sweet ass AI photo inmade of myself lol
Dang and I just threw one away.
Needs to be used and in working order. Near northern Idaho
I know a throne of cast iron blocks and cylinder heads would weigh like 42 tons, but I kinda want one.
#IfIwinthelotterytherewillbesigns
#IfIwinthelotterytherewillbesigns
I have a couple of used 208c 27 spline.I pulled them out of trucks that I parted.
I could pull the input from one for you
Ne
Need the whole TCase for a customer it sounds like we got it covered now though.
Started on a trail gear solid axle swap today for a 1988 4runner. And here is the square that needs a new transfer case next to mine
