DIY4X engine crossmember question....HELP PLEASE!!!

[bp71k5]

If it makes Hoby feel any better, I just replaced my oil pan gasket and had a lot of trouble getting the stock crossmember bolts to line up again, even though they were the exact same holes a few hours earlier. If I have to do that again, I'm going to do the crossmember while I'm at it.

 

[Big Blzn]

Ohhhh crap. You shoulda just did the cross member now.

 

[bp71k5]

Ohhhh crap. You shoulda just did the cross member now.

Probably. I didn't replace the rear main seal either and I probably should have. The front and rear oil pan seals were leaking and I was hoping that was it, but I'm starting to see a little oil back there already. I'll give it a week or two and see.

 

[scottishdave]

Wrenching through the troubleshooting process by the Ol' process of elimination is a mother. On my list of possible solutions to any problem on my vehicles, it almost always ends up being the last one.

 

[Big Blzn]

Wrenching through the troubleshooting process by the Ol' process of elimination is a mother. On my list of possible solutions to any problem on my vehicles, it almost always ends up being the last one.

Bingo! And I tend to fock up that last option.