Fuel filler hose?

[blazinzuk]

Extend your end that has the gas cap with metal tubing and then your hose won't be to short.

Just take it off the vehicle to weld it up.

This I have also just put a peice of tube in the hose never had an issue

 

[jekquistk5]

This I have also just put a peice of tube in the hose never had an issue

I do have lots of 1.75" tube left.... I guess thats the cheap way.

 

[magik235]

This I have also just put a peice of tube in the hose never had an issue

I have also used a metal tube extension splice to extend hoses several times.

 

[jekquistk5]

Done

 

[K85 Octane]

ahahaha

that'll do it

 

[BoondocK5]

Done

Thats the rustiest (is that a word?) fuel filler neck I've ever seen. Did you get that off the a horseless carriage?

 

[Deuling]

Thats the rustiest (is that a word?) fuel filler neck I've ever seen. Did you get that off the a horseless carriage?

Hey meow!! You come up to the Michigan, and you will see many a rusty auto part....

You would love how our brake lines look...


Oh and Jess, nice job on that, why did you cut it in the first place though?? I took mine off yesterday (was rustier lookin than that...) and sprayed some penetrating oil on the edge of the rubber, waited a few min, and it slid right off.....

 

[jekquistk5]

Thats the rustiest (is that a word?) fuel filler neck I've ever seen. Did you get that off the a horseless carriage?

That was the better of two I had . The other one had holes on it

 

[wazzabie]

Is the fuel filler hose 1.25 in ID on the 73-80 and 81+ is the ID 1.75in?

 

[85-K5Blazer]

My 1985 is 1.75 inch (not sure if it makes a difference, mine was Diesel with large tank not factory 25 gal)

Replaced mine last year got it from RockAuto.

I bought a Gates 24074 1-3/4" X 18" and I cut it to fit. $19.26 ..

The Vent Hose I had to have was 5/8" as mentioned earlier in the post.