stroked_jimmy
Registered Member
- Joined
- May 6, 2013
- Posts
- 18
- Reaction score
- 0
Hi,
I caught the 4x4 bug in the early 70s and bought a 73 Blazer which I loved and was regretfully talked into selling when the big gas shortage struck.
At that time I bought a 58 M38A1 jeep that had been converted to 12volts and spent the next 4 years with the help of my dad and uncle dropping in a 327 ci Chevy V8 and a few transmissions in her along with becoming familiar with every part on her and joined a jeep club in CA.
I still have her however she needs to be gone through again.
I picked up my 1988 Chevy Shortbed Step-side I am now rebuilding with a 383 stroker engine, headers, dual exhaust, and custom chip set.
My current focus is on finding 3/4 ton Chevy front and rear drive axles running 4.10 gears for the added strength if it is possible rather than buying just the ring and pinion gear sets and having them installed.
If any of you have experience if this will work and if so what additional work is needed to get the 3/4 ton axles to bolt to my truck.
Thanks in advance,
Tim-
3/4 ton front axle is a dana 44, same as a 10 bolt and a waste of time swapping. go 1 ton with the dana 60 front
So a trollin I shall go!!!! 

