K20 Motor Swap thread!

[cheyennek20]

your truck kinda reminds me of Muddin Manny's...

how about a video of it running?

It's in process if the wifey can get it to work. I can't figure out how to get it off my camera.

....And as long as I don't remind you of Muddin Manny!!!

 

[Dangerousdan]

Swap

Can you tell me what carb you have and did in come from Summit? Your swap looks great. Nice job.

 

[cheyennek20]

I got my carb fom Sean Murphy Induction, here's the website:

http://smicarburetor.com/

He was cheaper than Summit on the Jet Q-jet that I was looking for.
He also used to work for Jet performance, and knows how to build them. I've only had to adjust the idle bleeds and set the idle.

IMO it's a fantastic carb. I really have yet to beat on it though.

 

[Mike D]

Looks awesome!!! I noticed your high voltage wires look nice, neet, and parallel. I was always told they need to cross each other near the cap to prevent induced plug firing. You might want to discuss this with a mechanic.

 

[Yobtaf]

Well I think Chris is off to Iraq again. I think he said it was his 4th time going, so we wont see any build for awhile. Our prayers our with you brother!!

 

[throttleissues]

Looks awesome!!! I noticed your high voltage wires look nice, neet, and parallel. I was always told they need to cross each other near the cap to prevent induced plug firing. You might want to discuss this with a mechanic.

Theydon't NEED to cross each other, but it's recommende that IF they cross each other to make it as perpendicular as possible. Running along parallel and right against each other is not a good idea, but if you run clips to keep a gap it's fine. Yes, I'm a mechanic.