Kain
3/4 ton status
Mine does not have that curved metal but the sleeve is needed
Keep it and when you do your swap put poly back in will last longer
Keep it and when you do your swap put poly back in will last longer
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Motor mount replacement
- Thread starter TJ1978
- Start date
Kain
3/4 ton status
Also the smaller metal prices reuse those on the rubber
Im Going to use the rubber top and keep the poly bottom since I can't find replacement hardware for that. The sleeve you refer to i have to reuse from the poly as well....if I can and if not I'll just have to leave the poly mounts on the transmission
Once I install the ORD motor mounts I'll put the poly back on the transmission mount.
Thanks for replying, possibly I'm asking too many questions... I'll keep quiet if I can for a few days or so..
Thanks again
Kain
3/4 ton status
na man was just busy today sorry for the delay answer
there has to be a sleeve on the bolt that goes through the trans
i will look for the hardware i found a source but cant remember where
there has to be a sleeve on the bolt that goes through the trans
i will look for the hardware i found a source but cant remember where
Kain
3/4 ton status
thats them, but there was a place i had found for bolts sleeves and all stock stuff
just have to find them
just have to find them
How far up can I jack the the Tcase without damaging anything? I had it up but was afraid to go too high. So I couldn't get the ploy mount out... so I just put the bolt back through.
There is that piece that goes into the crossmember where the sleeve goes through.
all the way to the floor board, just watch the t case shifter.
Won't harm the transmission?
I have ORD twin stick
no won't hurt the trans. I am not familiar with the twin stick linkage enough to know if it will limit or get pinched in between the trans and the floor board.
You shouldn't need to raise the the t case tarns much to change those mounts.
Raise it up a 1/4" and slide the mounts to the out side to move and then slide new ones in
You shouldn't need to raise the the t case tarns much to change those mounts.
Raise it up a 1/4" and slide the mounts to the out side to move and then slide new ones in
