pvfjr
1/2 ton status
Yep, generally we use something with a 3/4" ID and drill it out to 53/64. Most of the time you can buy the drill bit and tap together as a matched set.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Proper cross-over steering modifications.
- Thread starter BadDog
- Start date
But that left hand tap is $$$
pvfjr
1/2 ton status
Indeed. That's why everything I have is RH. Adjusting them sucks, and you have to do it incrementally. No more fine tuning your alignment, but it gets plenty close enough for a wheeler with swampers.
garlicbreath
1/2 ton status
The right hand tap is about 30 bucks so it's not too bad.
When I ordered my drag link from trevor at WFO I had him tap the left hand threads, and I'll do the right.
I just don't have the patience to be pulling tie rods off to adjust alignment.
When I ordered my drag link from trevor at WFO I had him tap the left hand threads, and I'll do the right.
I just don't have the patience to be pulling tie rods off to adjust alignment.
pvfjr
1/2 ton status
I hate it too, that's why I don't adjust it. "Just set it and forget it" 
