SOLD!!!!Dana 60 SRW Front Axle 4.10

[GonicGM]

Dana 60 SRW 4.10 kingpin front end from Chevrolet K30 one ton 4x4
Housing: fairly clean, undamaged, unmodified, shock mounts good.
Knuckles: spindle surfaces flat filed, face and ID coated to prevent rust and seizure.
Axles have good u-joints.
Spindles: Pin needle de-scaled, wire brushed, flat filed and cleaned, needle bearing lubricated, mating surfaces coated to prevent rust and seizure.
Caliper brackets: Pin needle de-scaled, wire brushed, faces flat filed, faces and ID coated to prevent rust and seizure.
Locking Hubs: Warn, manual.
Passenger side pumpkin
$795 as it sits
Have DRW hub/rotor assemblies to convert to DRW if needed. $495 as DRW
Can arrange free delivery off rts. 95 128 93 495 395 from Wells Me. to New London Ct. (NH, Maine, Mass. Ct. RI)

 

[GonicGM]

to the top

 

[swettysblazer]

Is this a bolt in and go setup? And do you have a matching 14 bolt for the rear?

 

[GonicGM]

Is this a bolt in and go setup?

No, I recommend you clean, inspect and repack wheel bearings, R&R as required, top off diff oil, service brake pads and calipers, R&R as required.

And do you have a matching 14 bolt for the rear?

Yes, it is also listed in suspension/axle.

 

[swettysblazer]

What would you take for a package deal?

 

[NorCal_Chris]

hrmm... Wonder what this would cost to ship to CA?

 

[THE TURD]

do you still have the dana 60 ? how much to ship to 80504

 

[GonicGM]

Bump