How thick of a wall on a 1.25 SS tubing do think I would need so it would not crush in a bender when doing a 90 degree bend?
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Stainless steel tubing question
- Thread starter cuervo
- Start date
no experience, but i would think you could do .090 without probs....
Cornfield creations
1/2 ton status
Depending on the grade of stainless. If it's T-304 chances of pipe kinking is highly likely. If it's a grade T-409, 16 gauge would probably be good, 18 gauge is probably going to crush/kink. I am going off of exhaust tubing experience. Hope this helps
