Ya they cleaned up good.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Steve’s 66 chevelle
- Thread starter fastazz81
- Start date
beags86
Eastbound and Down
Good.
I am disappointed I paid 25 bucks to just to see this thing still looks like a cow thou.
I am disappointed I paid 25 bucks to just to see this thing still looks like a cow thou.
Send me your credit card info.
beags86
Eastbound and Down
Would love to, but if you seen my update ( which I know you did) you'll know it's just going to decline the first time you use it.
Flow Rate Calculator - Pressure and Diameter | Copely
Our Flow Rate Calculator will calculate the average flow rate of fluids based on the bore diameter, pressure and length of the hose.
www.copely.com
Some more fine tuning on the trunk panels and need to fab up a patch panel for the back if the wheel tub. Hopefully get that all done today and burn it in tomorrow.
Inner wheel house patch made and burned in ,no body shops will be beating down my door but a little undercoating on the outside and some trunk paint and it will be hard to tell my grinder was there.
Plan for tomorrow is get right side floor pan trimmed and to get it and supports burned in.
Supports burnt in, I should be grinder certified after this.
I'm just trying to blend the sheet metal...
Right side mostly burned in.
Little Black Friday shopping for the chevelle.
Only if I want to do something other than 1 leg burnouts, or snap 10 bolt shafts.
That H.O.305 is a monster.
Specs? Looks like a good upgrade!
Currie 9" housing i am guessing. They 15% off this weekend
