CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
The 56" front springs are hung!
- Thread starter DPI
- Start date
willymonster
1/2 ton status
question for dpi
saw your thread on the 56s and the rockwells and i was wondering how much clearance you had between the oil pan and the top of the rockwell box ? i was thinking on doing the same thing but the clearance issue scares me
got anymore pics ? id love to see it !!
saw your thread on the 56s and the rockwells and i was wondering how much clearance you had between the oil pan and the top of the rockwell box ? i was thinking on doing the same thing but the clearance issue scares me
got anymore pics ? id love to see it !!
DPI
1/2 ton status
Plans changed. I could not get the ride height low enough with the leaf springs. The springs were interfering with the hydraulic ram. I had atleast 4" of clearence above the top of the rockwell and the crossmember. It was not an issue. Those springs provided way too much lift for my taste even mix and matching and removing leaves....
willymonster
1/2 ton status
springs
sorry to hear that thanks for the quick reply
sorry to hear that thanks for the quick reply
DPI
1/2 ton status
Here's some more pics.
y5mgisi
1 ton status
theyre off of 2 1/2 ton miltary vehicles. aka duece and a half's.
willymonster
1/2 ton status
Pads
im assuming you went to coils or coilovers if so you wana sell me the spring mounting pads ? i really could use them if not where did you get them ? thanks for putting up more pics
like i said to bad it was to high for ya it looks like it all fit pretty well. ive come to the realizationthat mine is going to have to be high im just gonna try it and hope i dont flip on mr side to often 
im assuming you went to coils or coilovers if so you wana sell me the spring mounting pads ? i really could use them if not where did you get them ? thanks for putting up more pics
like i said to bad it was to high for ya it looks like it all fit pretty well. ive come to the realizationthat mine is going to have to be high im just gonna try it and hope i dont flip on mr side to often 
pennsylvaniaboy
1/2 ton status
updates man updates
DPI
1/2 ton status
No update on this project. Other than it's in few pieces spread across the USA...
TruckNutzDude
1/2 ton status
ChrisHall1985
Registered Member
i know this is old but i wont run 56 on my blazer build with dana 60 and wont to know how much lift you get with stock spring
