CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.

The Shop Truck

1971 Chevy C20 with a custom flat bed.
OK, I tested with the oscilloscope and everything looked good. I called Fuelab and it turns out their instructions are wrong... Their instructions state that it's a +5V PWM signal, when in reality it's supposed to be a ground PWM signal where 90+% duty cycle is slow speed and 20% and lower is full speed. That makes more sense when you think about the fact that open circuit = full speed and grounded out = slowest speed.
Unfortunately it still doesn't like having one pump off, so I'll try the diode trick next, but that probably won't be until next week, we're camping this weekend. I can always just leave that wire disconnected on the secondary pump, but I'd rather have the speed control if I can.
 
Well, we didn't go camping because we're sick, but I did test with the diodes. It works as intended with both pumps running or either one off as long as I have a diode on each of the signal wires coming from the pump.
Saturday is the first running of the Copper State Cruise and Race in Tucson. We're registered in the "heavy hitters" class I think, but that's only for cars that weigh more than 4000lbs. We're definitely way over that. We paid for test and tune on Friday, so we can get the dual pumps sorted out and build a tune that will go down the track. I'm not looking to get my 9 this weekend, I'm just trying to get it to reliably go down the track in the low 10s. Once I have that sorted I'll get new tires and go for a 9.
 
Top Bottom