Weld in Steering Brace - $65 shipped

[jjlaughner]

Weld in Steering Brace - $65 shipped -pending
New sitting a USPS box ready to roll. bottom and side plates both, long side plate like from ORD (probley was from ORD originally)

Paypal is good!

 

[jjlaughner]

should fit ’73 to ‘87 pickups (up to ’91 Blazers) GM F/S 4wd

 

[jjlaughner]

nevermind its sold!

 

[4bynut]

Can you post pics? Does it go on the inside or outside of the frame. Thanks Jason

 

[jjlaughner]

Can you post pics? Does it go on the inside or outside of the frame. Thanks Jason

outside and bottom I believe

Bolt it inplace of the box, hammer it out till it fits snug, clamps all around, weld in the holes, then around the outside where the round sections are, leaving inch gaps between the welds (same with the bottom). Requires some fitting.

http://www.offroaddesign.com/catalog/steeringkit.htm


There was a video that use to be up on here of someone welding it on, I found the post the video is no longer hosted (its was a 2004 post).

 

[blasphemous]

nevermind its sold!

Is it indeed sold?

 

[jjlaughner]

Is it indeed sold?

IT IS SOLD! shipped yesterday