Got the seat bracket all welded and drilled up. Ready to accept the the new Corbeau seats, then removed it for cleaning and painting. Then cleaned up the inside of the cab, again.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
The gray interior pic is different angle than my pic, but, using it for comparison.
I wire wheeled the entire floor, the used an air sprayer to blow all the debris out.
Then proceeded to temporarily run out of black spray paint, so I used yellow, what I had available.
I’m attempting to keep the metal painted to keep the whole rust issue at bay. Any paint will do until I get the flex seal on the entire floor. Next week…
Then I used some 3/4” angle iron I had laying around to recreate the door seal rib, down on the door sill. I drilled holes every 2 inches to weld it down.
Very happy with the results.
Then proceeded to temporarily run out of black spray paint, so I used yellow, what I had available.
I’m attempting to keep the metal painted to keep the whole rust issue at bay. Any paint will do until I get the flex seal on the entire floor. Next week…
Then I used some 3/4” angle iron I had laying around to recreate the door seal rib, down on the door sill. I drilled holes every 2 inches to weld it down.
Very happy with the results.
