Get some 1/2" pex and cut a piece long enough for your door strikers and slit it to install. They will latch so much better.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Never understood why people do this when a new striker is like $12
Until you loosen the striker and the bolt plate falls out of the back cuz the weld was broke years ago. A new Striker does not fix the problem.
I guess I'm lucky I can just reach around and grab it with my hand.
Huh…huh…he said “Reach-around…”
After I posted it I was like someone going to say something.
the new ones suck, that why.
Installed the carpet kit today. Seriously PITA. Had to use a few ratchet straps to unbolt and lift the seat/bracket assembly off the floor for the carpet to be laid where it was.
Last edited:
I took the good Keith’s (kgblazerfive) advice, and “DID NOT” have my driveshafts made from the schedule 80 pipe that I bought.
I should get them back next week from GRS driveshafts, here in 801.
Hopefully, they’re as good as they say they are.
I should get them back next week from GRS driveshafts, here in 801.
Hopefully, they’re as good as they say they are.
I've used them for a PTO shaft. They are the only ones I could find who did them. Was like $800 bucks on the company and then my guys threw it out of the truck doing stupid shit shortly after.
Watch out everyone, I Got my driveshafts back from GRS driveshafts.
She is very close to being mobile, under her own power.
They look great, fit great. Good price too!
They told me they used 0.095 wall thickness tube.
She is very close to being mobile, under her own power.
They look great, fit great. Good price too!
They told me they used 0.095 wall thickness tube.
