I see. You can’t say monkey anymore... it’s racist.The side tubes do 0% to hold it up. And after looking at it when folded down, those tubes would stick up like a spider monkey.
I see. You can’t say monkey anymore... it’s racist.The side tubes do 0% to hold it up. And after looking at it when folded down, those tubes would stick up like a spider monkey.
Well of course, I am very articulate ya know.I see. You can’t say monkey anymore... it’s racist.
I would, except all I have are 1/2-13 bolts. I want it to use the same size as my lugnuts so I have spares.Weld the bolts to the flange instead of studs?
See, you should’ve run the exhaust through the spare tire carrier and used that jet propulsion to keep the tire upGot my exhaust tip put on finally
View attachment 275608
Haha, I actually did think about running it out the quarter panel like @skunked did, but obviously I’m not as cool. Actually lazy. Haha.See, you should’ve run the exhaust through the spare tire carrier and used that jet propulsion to keep the tire up
No biggie. I’m not sure if I’m going to cap it yet.Want some caps for the bumper ends when I stop by? Table is loaded up from cutting my floor
