I have a tub.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
'86 Jimmy 4in Lift, 40’s, tons, 8.1 Swap- 700r4 said PNNNNN
- Thread starter GWeakland620
- Start date
This is not a dedicated trail rig, but does trailer to the destination usually. I am currently in the planning phase of doing a 52/56" spring swap, and getting back to being more road worthy.
peanut butter worked one time as a trail fix 
LOL
Got these in the mail yesterday. Along with instructions to super glue. I’ll giver a go in the next couple days.
Minus a very small bead leak, I think we are good to go. And that may settle down once I drive on it.
Ps, ignore the other bubble, they are inactive.
Ps, ignore the other bubble, they are inactive.
Get some of this for your beads in the future. Works really good on corroded aluminum rims and rusty steel ones.
Yeah, we used that stuff at the tire shop I used to work for. The thing is, this wheel was clean. Not sure why it would be leaking out of the bead area.
Yeah it should seal up I bet.
Steering shaft is leaking on my steering box. Is that just a press in seal, or do I have to tear into the box?
Mark the location of the input nut and back it off with a punch or something. You can change the seal after that.
I watched a couple YouTube videos about Saginaw box rebuilds. Very helpful videos out there.
I watched a couple YouTube videos about Saginaw box rebuilds. Very helpful videos out there.
And it did. Started with 15psi on Tuesday with that small bead leak. It leaked down to 14psi and is holding right there. I’d say it just needed to sit a few minutes.
great video showing an entire tear down
How do you fix this?
brokenparts
1/2 ton status
Vice grips might work too.
Vise grips spun right off and I don’t have a welder.
My brother suggested cut it off and order another one.
My brother suggested cut it off and order another one.
brokenparts
1/2 ton status
Use your man strength.
brokenparts
1/2 ton status
More out the box thinking... cut a notch in the bolt and then wedge an old screw driver in and wedge it up against the wheel hoop.
Couple batteries, jumper cables and a welding rod 
