89 Suburban is gone....added a K5 in it's place..87 V30 WONTON

[Desert_K5]

Not much happening with the K5, just been taking it out and doing maintenance. Pulled retrieval and medical response assistance (hauling injured racers out of the tough spots) for the bikes and UTV's Crater Flats, NV & Parker, AZ. Hiking with the family and mutts. Also want a smudge pot bad. Looks like a fun pit to bring along. Building and wrapping some cool things. Bashed up the car hauler on Shea road. Shitty road. Super thankful I'm able to do this and still having family around to enjoy. Keep your family close brothers.

 

[Desert_K5]

Aluminum cup holder completed. I'll mount it up after work. Side note, I can make these in single or dual cups if anybody would like to add these to their build. Single cup is $25 and dual is $40 plus shipping at cost.

 

[Desert_K5]

I'll probably add a small piece of rubber for cushioning if needed. We shall see.

 

[mrk5]

Funny, I was just thinking about making the same, but if you're already doing it I can be lazy. What diameter is the hole? I need 4".

 

[Desert_K5]

It's 3.5" but I can adjust the file if you need 4"

 

[Desert_K5]

The top will have a small protrusion to keep the frame stiff with a 4" dia.

 

[skunked]

I've been looking at fabbing something similar to bolt to my bench seat frame With the manual it's a bitch to hold a drink, steering wheel and a shifter.

 

[mrk5]

The top will have a small protrusion to keep the frame stiff with a 4" dia.

View attachment 372016

I would like a double holder and I have 10-1/4" total width available.

 

[Fastereddie]

I've been looking at fabbing something similar to bolt to my bench seat frame With the manual it's a bitch to hold a drink, steering wheel and a shifter.

#realtransproblems

 

[Bent77]

I need a 4" hole

I doubt it

 

[Bent77]

#realtransproblems

Wording. Just awful...

 

[Desert_K5]

Gender neutral sometin sometin

 

[Desert_K5]

I would like a double holder and I have 10-1/4" total width available.

I'll get it cut up

 

[Fastereddie]

Wording. Just awful...

I knew you’d pick that one up haha

 

[Desert_K5]

@mrk5 here you go. 10 1/8” wide 3” high by 4 1/2” deep. 4” dia. Cup holes. Pm your address and I’ll send a total to your email.

Any other orders let me know I’m cutting aluminum tonight and tomorrow all day.

 

[skunked]

Can you provide the dimensions for the dual with 3.5” holes?

 

[Desert_K5]

Can you provide the dimensions for the dual with 3.5” holes?

Same. The holes are just reduced. Do you need a smaller setup?
I can build just about any size you'd want. I build the files from scratch and adjust per order if necessary.

 

[Desert_K5]

I'm thinking about building a taller one so the cups sit deeper for bouncing around.

 

[mrk5]

Damn, that was fast! Looks very nice, too!

 

[Desert_K5]

Damn, that was fast! Looks very nice, too!

Thanks! I'll get it boxed up and send over the total. I appreciate the order