Woops, I didn't mean to post those in the reply... Oh well
But yeah I got the dash in and finished the seat mounts
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
91' Blazer 6.0 LS, 4l80e, Nose swap, Full Top Conversion, and Restoration
- Thread starter Coontail
- Start date
But yeah I got the dash in and finished the seat mounts
Yeah I was wondering what you are trying to tell me
Lol my badYeah I was wondering what you are trying to tell me
no worries.
Reinstalled the dash and with a little trimming it fit pretty nicely around the cage
Stripped the quarters and am currently do a bit of rust repair and some body work
Stripped the quarters and am currently do a bit of rust repair and some body work
Not much else to say other than I've been doing A LOT of sanding, I'm hoping to have the whole thing in high build primer by the end of the month
Also not too impressed by the Klean Strip paint stripper, didn't even touch the paint until 4 very heavy coats and even then I ended up DAing the whole thing
More exciting posts to come
One bedside done!
Another patch..
Fabbed up some custom brackets for the fan, condenser, and coolers. Just a little bit of finish work and it'll be good to go
Primer on the body should be within 2 weeks
Fabbed up some custom brackets for the fan, condenser, and coolers. Just a little bit of finish work and it'll be good to go
Primer on the body should be within 2 weeks
RoccoK5
1/2 ton status
Looking good! Quite the assortment of coolers! 
Haha yup I went a little over killLooking good! Quite the assortment of coolers!
You might have trapped air problems with your cooler mounted in that configuration.
Think so?
History repeats itself
In progress:
Copper nickel brake lines
Installing the engine
Reconfiguring wiring harness layout
Sending unit
And few a more goodies
I should be having it running and driving again by the end of the week
In progress:
Copper nickel brake lines
Installing the engine
Reconfiguring wiring harness layout
Sending unit
And few a more goodies
I should be having it running and driving again by the end of the week
Photo dump
More wishful thinking to come
More wishful thinking to come
RoccoK5
1/2 ton status
Looking good! What's left before you can drop the body back on the frame?
I just bought that same 22 pin bulkhead connector for my LS swap.
I just bought that same 22 pin bulkhead connector for my LS swap.
Looking good! What's left before you can drop the body back on the frame?
I just bought that same 22 pin bulkhead connector for my LS swap.
I actually just dropped it on tonight! Forgot to take a picture
The bulkhead works great but make sure you order a bunch of spare plugs for unused pins
Primer this weekend???
Finally something went as planned
Really starting to get motivated now
Really starting to get motivated now
It runs! Again!
RoccoK5
1/2 ton status
Looks and sounds great! That's not open headers, is it?
Last edited:
