Going to want the front shorter, get real close to the tire if you go bigger tires.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Boatsided crew cab with doors
- Thread starter Crizpy1969
- Start date
Looks good. I'll agree that the front of your 2x6 tube should be cut back a hair shorter.
handloader90
Building!
Sub'd.
Crizpy1969
F-Bomb fab
That's not where they will end up..just cut off quick.
Crizpy1969
F-Bomb fab
It will be when the fenders are done.
Crizpy1969
F-Bomb fab
I couldn't help myself. .I had to change the hood some. .few tubes weld in.
Not sure about the hood, but the rest is looking good.
Crizpy1969
F-Bomb fab
I guess it doesn't look terrible. Maybe once some paints on it, it might look ok.
beags86
Eastbound and Down
It's not horrible, mud it and paint it and it will probably look pretty cool
I agree
Following this, I am planning on boatsiding a blazer I just purchased I'll look to you for guidance
Crizpy1969
F-Bomb fab
Got drivers side floor all tacked in. 
Crizpy1969
F-Bomb fab
Well I got all 8 main tubes in and one rear one.. the 8 will get short tube gussets and the rear one a long one.
Very nice work!
Crizpy1969
F-Bomb fab
I got all 10 tubes in. With 8 getting short tube gussets and the rear one a long one. One more piece for the floor then burn some wire.
Crizpy1969
F-Bomb fab
Wire wheeled the frame and used corrseal on it..love this stuff.
Crizpy1969
F-Bomb fab
Nice pair!
Crizpy1969
F-Bomb fab
Floor is cleaned and primed
