What's new
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.

Dana60 Wheel Bearing Nuts 6pt vs. 4pt ?

onetonbb74 said:
To pull the hub seal out: remove the spindle nuts and outer wheel bearing, put a spindle nut back on a few threads. Grab the rotor and pull off the entire hub assembly off the spindle.
Click to expand...
just do NOT use a inner nut for a 4 tab style with the index pin for this . you might break the pin off and be sol.

this trick works GREAT 95% of the time . some setups it wont work . but i just did it on my 60 front so it will work for you .
 
Well the "slide-hammer" trick worked... pass side a bit more "dry" A-one a-two a-three a-boom it let loose yeeeeeeHaaaaaaa!!
Spindle bearing are toast.. well dried up anyway and getting replaced...

Spindle_bearing.jpg

Splindle_bearing2.jpg
 
Can't remember what I used on mine,,, it's been a while since I've had it apart... but I didn't buy a special socket, so it must have been something I had in my box....standard 4 or 6 pin 4x4 socket ?

I will say I was very satisfied with the product,, went on easy, locks securely, and nicely machined. It flat works.
 
wasted wages said:
Can't remember what I used on mine,,, it's been a while since I've had it apart... but I didn't buy a special socket, so it must have been something I had in my box....standard 4 or 6 pin 4x4 socket ?

I will say I was very satisfied with the product,, went on easy, locks securely, and nicely machined. It flat works.
Click to expand...
Sweet! Yeah my header bolts were installed in 2005 = Thorley Tri-Y BBC..... Zero leaks to this day! :saweet: Stage8 I am a fan!
 
You must log in or register to reply here.

Latest Posts

Top Bottom