What's new
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.

Engine crossmember/panhard kits

Very good guy to work with, just have to be patient due to his work schedule. Absolutely worth the wait though.
 
I sent him a PM on a local board, he was on there 2 days ago, told him about this thread. Making sure he didnt forget about yall.
 
i messaged him as well.... anyone else have any feed back on these? any issues or clearance with oil pans? i'm trying to order one so i can get my new motor in and going.:D
 
Still making these?

Probably be looking for one by the end of summer.

Later,
Buddy
 
i got a email from him 3 months ago.

i have sent him 3-4 since then no reples.

prob gona look other place. but i liked his the best. :D
 
crossmember

dcubb said:
Hello everyone, my name is Dave Cubbage. I build engine crossmember/panhard bar setups for the '73 to '91 full size GM trucks.

I custom build these in my spare time as a hobby, more or less, so therefore at this point I don't pump them out in large quanities.

The basic engine crossmember is a stout piece that replaces the factory crossmember and is easily upgraded to utilize a panhard bar by just welding on the p/h bar mounting tabs. This crossmember currently sells for $130 plus shipping.
080419011.jpg

080419010.jpg



The crossmember/panhard setup combines the engine crossmember with a panhard bar that really wakes up the steering response on a rig with crossover steering. It pretty much eliminates all bump steer and has been proven to counter death wobble on a couple vehicles that it's been installed on. This setup will work with d44, 10b and d60 axles.
These currently sell for $330 plus shipping.

080419009.jpg

080419012.jpg

080419002.jpg

080419005.jpg
Click to expand...

Are you still building the engine crossmembers I would like to buy one
 
You must log in or register to reply here.

Latest Posts

Top Bottom