What's new
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.

Got any cool tools lately?

Fathers Day gift. I love this already. I checked air pressure on 3 trucks, 2 trailers, 2 tractors, a boat, a UTV, and a lawn mower in under 30 minutes and didn't have to move a single vehicle. Set the pressure and then stand up with your beer. ez peezy.

airpump.jpg
 
Big10 said:
Fathers Day gift. I love this already. I checked air pressure on 3 trucks, 2 trailers, 2 tractors, a boat, a UTV, and a lawn mower in under 30 minutes and didn't have to move a single vehicle. Set the pressure and then stand up with your beer. ez peezy.

View attachment 450475
Click to expand...
A buddy had the M12 version over the weekend. It was pretty slick. Net that M18 is a beast.
 
I just got the 2 gallon wet/dry vac and battery combo from Home Depot over the weekend.... so far so good.

www.milwaukeetool.com

M18™ 2-Gallon Wet/Dry Vacuum | Milwaukee Tool

MILWAUKEE® M18™ 2-Gallon Wet/Dry Vacuum is a Powerful and Portable Wet/Dry Clean-up tool. The cordless wet/dry vacuum creates suction for both wet and dry applications
www.milwaukeetool.com www.milwaukeetool.com
 
For checking spring seat pressure?
 
Just seat pressure would probably be ok for most I guess .? Full open pressure it probably wouldn't work for much though.
Cool tool.
 
Full open really needs to be at full lift. At least open is at installed height
 
I found out about seat pressure when I took my truck in to have the vales adjusted. Never heard about it before that.
Dude said my seat pressure was WAY high. Turned out the aftermarket springs the PO had in it were installed on top of the rotators lol.
 
I never did an update on the DeWalt magnetic drill.

Last week I ran 4 0.4250 holes for 12x1.25 threads for casters. Through 3/16 steel. Set the drill up, flipped the magnet switch on, flipped the drill on and went through with no issues. Nice and square. Did not have to pilot drill and step up bit sizes.

Just drilled 10 holes in the header for the lean-to. With set-up, it took 15 minutes to drill all of them. Nice and square through both sides.

PXL_20230626_231937868.jpg

PXL_20230627_000446652.jpg
 
ktmoutfront said:
I never did an update on the DeWalt magnetic drill.

Last week I ran 4 0.4250 holes for 12x1.25 threads for casters. Through 3/16 steel. Set the drill up, flipped the magnet switch on, flipped the drill on and went through with no issues. Nice and square. Did not have to pilot drill and step up bit sizes.

Just drilled 10 holes in the header for the lean-to. With set-up, it took 15 minutes to drill all of them. Nice and square through both sides.

View attachment 450828

View attachment 450829
Click to expand...
Mag drills are the shi-neezy
 
I gotta buy a set of those yet. All I have is 9/16 and 11/16.
 
You must log in or register to reply here.

Latest Posts

Top Bottom