ReTonkulous

[ktmoutfront]

Pet, pick, whatever.

 

[Chickntrk]

That reminds me, I need to call him

 

[Fastereddie]

This is what I found so far.

 

[ZooMad75]

I need some input from people smarter that me.

I can not find anything that shows engine oil flow direction for the oil cooler. I need to tap the cooler line adapter block for a pressure sensor. I am running my Autometer gauges at this time and the OBDII does not feed oil pressure for digital gauges.

The adapter block has a front port that goes out the bottom line. One diagram that was GM and was close in design, has the lower going into the top of the cooler.

Does anyone have a clue which direction the oil flows?

@ZooMad75
@Fastereddie

I’ll see what I can dig up.

 

[Fastereddie]

This seems to show the same. So front is out rear is in.

 

[ktmoutfront]

This is what I found so far.
View attachment 474496

I looked all over ICT site for something. Did not see that one. My assumption was correct. Sometimes my brain is correct in it's figger'n.

I’ll see what I can dig up.

@ZooMad75 No need now. Thanks.


I was just about to put the starter in to spin the engine to see where it came out.

 

[ktmoutfront]

I was not aware, that I needed to shave a guide bar out of the oil pressure sensor and remove a block in another plug, on a plug and play harness.

 

[Fastereddie]

I was not aware, that I needed to shave a guide bar out of the oil pressure sensor and remove a block in another plug, on a plug and play harness.

Never heard of that

 

[Chickntrk]

Sounds like a play harness

 

[ktmoutfront]

Play with the ends to figure out why they won't plug in. Everything but the coil packs are plugged in now.

 

[Chickntrk]

Does it run yet?

 

[sweetk30]

x2 on run yet ...... we all care despite your other problems . all the work you did we wana see it RUN

 

[ktmoutfront]

Harness is in. ECU and trans controller mount is being finished tonight.

Then the core support will go in and all of the plumbing, PS lines and cooler, AC, fuel, oil cooler, radiator, fans and a crap load more wiring.

And wire the line lock. Because

 

[Chickntrk]

 

[sweetk30]

my 2 wheel burn project got a line lock cause i needed a T-fitting and had one here so i used it . . . . cant wait to try it my self .

 

[ktmoutfront]

Shut it.

 

[ktmoutfront]

Computer mount is done and the paint is drying. Thought I would take 15 minutes and slap the starter in. Eat shield for the knock sensor needed finessing to clear the header. Took 45 minutes due to trying to align the knock sensor so the starter would clear. There is a round heat shield that goes over the sensor and takes up a bunch of space. Finally found its spot and everything went in.

 

[ktmoutfront]

Puter mount is done.

I may add some inner fender to protect it.

 

[Fastereddie]

Puter mount is done. View attachment 475116View attachment 475117

I may add some inner fender to protect it.

Looks really nice

 

[ktmoutfront]

I picked up the O2 sensors. Ordered up stream 2017 sensors. Nope the harness connector is for the down stream O2 sensors. What the heck?