That's better
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
What's up with this tag? Is it off of a 205?
Yes it is
I have had a few on later model 205's
Ok, I was wondering about the year but didn't realize it was a Dodge case.
It's a GM case now!
What's the difference?
Outwardly, not much
Has 23 input, which is better now
32 out rear, 30? Out on the front
Does not have the boss on the side of the case for the frame mount. Which is cool, because with it clocked, that's worthless
I will like to utilize that front output though, so I'll look for a CV chunk off a dodge so I can use the drive flange
Most, if not all, Dodge and Ford 205's have a 32 spline front output shaft.
They all do. GM is the only one with 10 or 30 spline front outputs.
Sell that 23 spline Dodge stuff somewhere, they aren't available new and fairly uncommon.
Took some looks under there this afternoon. I can sneak the duals past the t cases. I do believe I will drop the exhaust clean out and start over, moving the mufflers back always and getting a cross over back in there.
As it is, the summer fun has worked the exhaust donuts out
As it is, the summer fun has worked the exhaust donuts out
crossover behind the 205 and go through one muffler?
Keeping the duals,
Old school modern, correct?
Old school modern, correct?
wetoolowdingbangow
1/2 ton status
I say put a cherry boomer and then finish it off with fake 2 inch duals. 8 inch tips.
Yeah guess you could call it that. This one is not needing as much attention as the one on yours, but close.
Gonna drop it out, brush the rust off, grind the welds down and repaint eveything with the new layout
Gonna drop it out, brush the rust off, grind the welds down and repaint eveything with the new layout
wetoolowdingbangow
1/2 ton status
You just gonna use some high heat paint like vht?
