454Sub
5/8 ton status
I'm so glad mines back apart again. Those are so heavy they just plain suck to remove. Looks good. Did you make a new 203 vent?
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
I did not vent the 203, but the doubler plate is vented behind the seal
Nice!
Looks good man
Pretty dang cool, we should do a long bed photo shoot in Moab.
Remember what I told you at BB15 about your truck?
Remember what I told you at BB15 about your truck?
Um no. Still wasn't there in 15...Pretty dang cool, we should do a long bed photo shoot in Moab.
Remember what I told you at BB15 about your truck?
16...
The love hate relationship. I like the doubler you have going on, the gearing you will have is going to be ridiculous.
I think you told me it was sexy. That's what I remember16...
The love hate relationship. I like the doubler you have going on, the gearing you will have is going to be ridiculous.
Honestly probably won't need 105:1 very often. But I might. Definitely one of the things I will be cognitive of and then relay that back here later
Probably was the saddle blanket, I have mine half installed, cant seem to get a good pattern to hold it down correctly in the truck. I'll have to take it out and figure how to strap it down.
Bit of a PITA. I got in on and mostly situated, then started in the middle of the back and worked out, then the lower part of the seat. Fairly certain I went back and retighten the back afterwards
it really is, how did you get the bottom corner on the right hand side, towards the back? it doesn't seem to want to wrap around as good.
I think I did something creative. I will snap a picture tomorrow and let you know. Like I said, PITA.
But it stays pretty good even if you flip the seat up
Thanks, I have been going back and forth how to do it and can't seem to get a correct pattern I like and can live with. Right now the bottom isn't even strapped down...
Those I tied through the seat upholstery loops underneath. Again starting in the middle
Hmm, I thought all these seats were vinyl. I'll probably have to tie it off on something underneath.
Mine is, but there are metal loops under the seat
Are you talking about the seat cover? I pulled the seat out and had it on a bench so I could access all sides easily.
Well dang, I'm just going to have to pull the seat and go after it then.
#Benchseattech #saddleblanketmafia
You may now go back to the doubler tech..
You may now go back to the doubler tech..
