beags86
Eastbound and Down
Nice picture. I always enjoy lining up my stuff like that. But needs more square, less 400/800
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
‘83 C10 4spd Scottsdale-Gone but not forgotten. New replacement loading...
- Thread starter GWeakland620
- Start date
Mild restoration build to use as a truck should be used.
The gm400 would get replaced with a slightly lifted crew cab. The gm800 would get replaced with a lowered crew cab (since I don’t like the look of extended cab conversions).
Oooo even better!
The gm800 would get replaced with a crew cab short bed. Oh yeah. Schwing!
beags86
Eastbound and Down
Well get on it.
Spend some pennies.
Spent a little over an hour cleaning up crap inside this thing this morning. Found about 10 hand tools and some other random sockets. Then cleaned up a bucket full of dirt and nasty stuff from the floor board and under the seat. Still need to power wash the floor, but it looks way better. Floors are solid. Kick panel on the driver’s side had a small section of rust, but not bad. Going to wire wheel and paint it after I wash it out. Then maybe new floor rubber.
Before
Pile of dirt after scraping the floor.
Clean passenger floor board with just surface rust.
All the trash picked picked up. Just needs washed.
And the new seat. Decided to throw it in so I have something to sit on when I move it.
Before
Pile of dirt after scraping the floor.
Clean passenger floor board with just surface rust.
All the trash picked picked up. Just needs washed.
And the new seat. Decided to throw it in so I have something to sit on when I move it.
I always thing clearing the floor coverings and replacing the seats are the best ways to clean up a crusty old rig.
Yep agreed. I feel like I can relax knowing the seat isn’t hiding a snake or rat lol.
beags86
Eastbound and Down
Funny looking quadrajet
I’m not scientist but isnt motorcraft a ferd product.
Just put a tbi setup on it
Just put a tbi setup on it
I have a coworker that has and Edelbrock he said I can use. I guess I'll go that route. I really wanted a q-jet though. Would I be better off finding one still?
beags86
Eastbound and Down
Put that fast ez EFI on there and be done with it
What do you want me to do?!
Should I stay or should I go now?
Lol no way.
"Swipe one" as in a q-jet?
I know the tunability is there so that you can get good power and decent mpg's at the same time, right?
