I’ll section a piece and rebend it like @blazinzuk mentioned. Not sure if it will happen before the rubicon trip though. Have some other things are more of a priority.....
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
I’ll section a piece and rebend it like @blazinzuk mentioned. Not sure if it will happen before the rubicon trip though. Have some other things are more of a priority.....
Like this?
No, I have zip ties. The stock gauges are only needed for oil psi and fuel level, the rest is displayed on the fitech screen.
Knocked a few things off the list today.
- installed 4 degree rear shins and adjusted the anti-wrap.
- installed windshield
- cleaned up dash wiring, mounted the trans temp gauge and the CB.
- installed the rear view mirror & roll bar padding
- installed the tube doors
- installed 4 degree rear shins and adjusted the anti-wrap.
- installed windshield
- cleaned up dash wiring, mounted the trans temp gauge and the CB.
- installed the rear view mirror & roll bar padding
- installed the tube doors
Lookin bad ass mannnn! I'm Jelly, I need to make some progress!
Looks real good, like the way the floor turned out.
Yeah that is awesome
I may have ripped off my brand new “flexible” antenna pulling into the garage last night. I’ll blame the beers 
Everything work out good? No head hitting on the cage?
I have a good 4”+ between the hoop crossbar and my head. I padded those bars above both seats anyway. Everything but the gauge interference is good.
Rubber back under it, drove it around the neighborhood. Got a fist pump and a fck yeah from a neighbor down the street
CrpMag122
1/2 ton status
Nice!Rubber back under it, drove it around the neighborhood. Got a fist pump and a fck yeah from a neighbor down the street
View attachment 267044
The truck is deceiving. It looks like a solid day-2 build from 20’, but the details show up quickly.
David
David
Thanks guys.
Dropped the kiddo off at school, scared a half dozen soccer moms in the process. On the way to work I noticed a little bit of an issue with what feels like steering box slop but then when I make a small correction it feels like it's over steering so I'm quickly trying to counter that. I'm basically playing pinball down a single lane. After work I'm going to look it over closer and double check the alignment.
I had a similar problem tracking down the road, and found the pitman arm nut was starting to loosen.
David
David
that's scary, I'll double check that.
I know the box is tight to the frame, I checked that the other day.
Could be the new ram didn't get fully bled?
