CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Edelbrock Proflo 4
- Thread starter 6872xtc
- Start date
Use the coil power. The power to feed the new coil comes off the battery feed
Kain
3/4 ton status
might have to join this thread/club........................
thinking real hard on it................
OK IM ORDERING..............
thinking real hard on it................
OK IM ORDERING..............
Kain
3/4 ton status
did you guys have to disassemble to install manifold? fuel rails and throttle body?
not 1 bit . plop on and bolt down . unless you want rear inlet/outlet then its just swap the fuel crossover hose end for end .
Kain
3/4 ton status
what psi does the system need 58 or 43?
That didn't seem like a very long decision process.
I had my throttle body off at one point, but I don't remember why. I don't believe that it's necessary. I may have changed one or both of the back studs to slightly taller ones. The fuel rails are perfect handles.
Using a torque wrench on the center 4 bolts was a trick, I can't remember what I did. I would look at that before you get it on the engine where is easier to figure out. This manifold has large runners and plenum, so the bolts get crowded.
And you choose what pressure you want to run with the regulator that you buy. My engine is tame, I went 43 psi.
Kain
3/4 ton status
410+ hp i am going to get 58 psi, return style system already set up for
And my order is in.
have to wait till next month to install need fluids coil and a few other things but it will arrive aug 10th i think
And my order is in.
have to wait till next month to install need fluids coil and a few other things but it will arrive aug 10th i think
Kain
3/4 ton status
from what i have read noI’m seriously thinking about proflo too...I know I’m going to, I just don’t know when I want to see the scary CC bill
Will it control the 700r4 lockup?
Does not have lock up
@Scribbles , it doesn't have any transmission control at all. Mine apparently has a modified valve body, so it works the lock-up.
I don't know what would be your best option.
I don't know what would be your best option.
Kain
3/4 ton status
will call Edelbrock in the morning to see if 58 psi to much
do you have to hook fans up to system?
do you have to hook fans up to system?
Like was said it comes assembled, I did swap the crossover to the front on mine , I already had my fuel lines ran to the back so it was easier.went 43 psi on mine 30 over 350 vortec heads comp 268 cam , runs great !
You don't have to. Its optional on the fans. I got mine hooked up to the PF4 ECU and have them come on at certain temps. Fan 1 temp is different than fan 2 temp. Makes it nice so you don't need an electronic fan controller.
