Munched...add that one to the WAD thread...
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Added a new tcase crossmember which I got from @bmxbryant9 a few months back. Trimmed the edges and melted the 1/4 angle iron on the ends. 
Installed.
Took it for a cruise this am, seems fine. Now im going to pull the rear shaft and have it re-balanced.
I might end up getting a new one so I can use the old rear shaft for a spare.
Im going to check that first. I think my angles are off as well. I hear a decent amount of gear noise in the cab.
Also got the bender mounted on the slab out back...used 1/2 inch drop-in anchors. Probably fill them with antiseize and grease when the bender is in the garage...
What are you guys doing for a degree wheel on the bender?
If you saw the rock rash on it you would understand lol
That’s what I did.
Mine came with one but trick tools sells them too
Well finally ordered new spindles and a rear driveshaft... going 1410 cv in the rear and rebuilding my existing as a spare...also swapped my rear springs to the 52s from @bmxbryant9...
Put the tube doors back on, loaded on the trailer, leaving for the weekend tomorrow to go wheeling...my driveshafts should be done tomorrow. 
Where ya going?
Mud in yer eye...Hollister.
All loaded up...
All loaded up...
Lol, 1410 cv and now I have a spare 1350 cv shaft. 
lol, looks like a fk'n fishing lure 
and who makes that tool bag? I need one of those and I've only found one company that makes them and they're waaaay too proud of their stuff.
Atlas 45, and there very proud!
they sure are....I'll keep looking.
